[PD] Comport under Linux - baudbits question

[Jose Luis Santorcuato]

Yes, and then upload your serial sketch or whatever.

José

2011/4/13 Jose Luis Santorcuato <santorcuato76 at gmail.com>

> Hi, maybe you must change in the Arduino IDE the baud to comunicate...in
> Arduino terminal...
> in the tabs to upload, run,stop, etc, find the last  (on right) which
> corresponds to terminal, open it and setup the baud of Arduino, do not
> quite understand what you say, but might work.
> Check the pic
>
> http://emulare.sourceforge.net/manual/ArduinoTerminal.jpg
>
> In Linux is the same
>
> Best regards
>
> José
>
> 2011/4/13 J bz <jbeezez at gmail.com>
>
>> Hi all,
>>
>> Just transferring a patch into Linux from W7 and I get this message in the
>> console which I didn't previously:
>> get_baud_ratebits: 115200
>> set_baudrate baudbits: 4098
>>
>> Now I want the baudrate to be 115200, which is good but what does the
>> baudbits info mean - for example is it telling me that data is only coming
>> in at 4098? Which I don't want, or, seems a waste if the overall patch is
>> expecting a much faster rate.
>>
>> Cheers,
>>
>> Julian
>>
>> _______________________________________________
>> Pd-list at iem.at mailing list
>> UNSUBSCRIBE and account-management ->
>> http://lists.puredata.info/listinfo/pd-list
>>
>>
>
>
> --
> http://arselectronicachile.blogspot.com
> http://comunicacionnativa.blogspot.com/
> http://www.myspace.com/santorcuato
>
>
>
>


-- 
http://arselectronicachile.blogspot.com
http://comunicacionnativa.blogspot.com/
http://www.myspace.com/santorcuato
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.puredata.info/pipermail/pd-list/attachments/20110413/3be6fc3c/attachment.htm>