[PD] Pduino + XBee

[Martin Peach]

On 2013-05-20 17:48, Abel Jérôme wrote:
>> If the xbees are in regular modem mode (not API) they should be
>> transparent as far as the connection goes.
> That what I though.
>> You just need to make sure the baud rate is the same on everything.
> I start to reset the default settings :
> Receiver (connected to an Arduino) : ATRE, ATMY1, ATWR
> Sender : ATRE, ATMY2, ATDL1, ATWR
>
> The ATID is the same by default, so it should be ok.
> When I use these settings with 2 arduinos, it works. And I've tested
> settings succesfully with direct connections between XBees.
> I don't understand. May be Firmata is waiting special messages to be
> start...

Maybe the xbee is sending something when it starts up or connects that 
confuses the arduino into going into bootloader mode?

Martin