[PD] arduino ProMicro problem with no. "13" coming in as "10" (Ubuntu 11.10)
Ingo
ingo at miamiwave.com
Sat Feb 6 18:06:23 CET 2016
Thanks Jan!
I just did that but have no clue what these parameters mean or how to change
them. I have already created a /etc/init/ttyACM0.conf but don't know how to
enter any correct values.
Here are (only) the differences of the two outputs:
good midi in unit: bad midi in unit:
-cstopb cstopb
-clocal clocal
ixon -ixon
ixoff -ixoff
opost -opost
isig -isig
icanon -icanon
-iexten iexten
echo -echo
echoe -echoe
If you (or anybody else) could give me a hint which of these settings might
cause "13" to come out as "10" problem and how to change those settings I'd
be extremely grateful!
Ingo
> -----Ursprüngliche Nachricht-----
> Von: Pd-list [mailto:pd-list-bounces at lists.iem.at] Im Auftrag von Fred Jan
> Kraan
> Gesendet: Samstag, 6. Februar 2016 16:33
> An: pd-list at lists.iem.at
> Betreff: Re: [PD] arduino ProMicro problem with no. "13" coming in as "10"
> (Ubuntu 11.10)
>
> On 2016-02-06 03:00 PM, Ingo wrote:
> >
> > Does anybody have an idea how to fix this?
>
> You might try to compare the output of 'stty -a -F /dev/ttyACM0' on both
> systems. It might be the newer Linux has a different idea about the
> terminal type of /dev/ttyACM0.
> >
> > Thanks!
> > Ingo
> >
> Greetings & success,
>
> Fred Jan
>
> _______________________________________________
> Pd-list at lists.iem.at mailing list
> UNSUBSCRIBE and account-management ->
> http://lists.puredata.info/listinfo/pd-list
I'm having a strange problem with the transmission of my Arduino ProMicro
MIDI interface on Ubuntu 11.10 (kernel 3.13).
It shows up as ttyacm0 in the system.
Every number "13" that I transmit which could be controller number "13" or a
value like program change "13" comes in as number "10".
I suppose it is being recognized as a carriage return (13) which is being
executed and then followed by a line feed (10) that actually gets
transmitted to the [comport] object for some reason.
Does anybody have an idea how to fix this?
Is there a ttyacm.conf (or similar) somewhere in the system that I could
edit for a normal (non modem) behavior?
Or can I set up the arduino to show up as a different device other than
ttyacm?
On my other operating system everything is working fine with the same
arduino and programming coming in as ttyacm0 - no special changes. Just
another Ubuntu 11.10 with an older (original 2.6) kernel.
Thanks!
Ingo
More information about the Pd-list
mailing list