hia, some months ago there was a thread about controllin' step motors
from pd to the arduino, it went as it often goes, into a very technical
discussion and at the end im not sure if it is or is not possible to
control this kind of motors via pduino or any other way.. i just want
to be able to use the board and the motors from pd, can that be achived
with the actual pduino?<br>
<br>
can anyone share a pd patch for doing so, im sending a sequence of
values to the pins in the arduino where the stepper is connected
(previously tested the wiring and it all works fine with a
potentiometer) but it only tics and doesnt move no matter the pattern i
try.<br>
<br>
this is the thread where things where being discussed:<br>
<a href="http://www.mail-archive.com/pd-list@iem.at/msg00315.html">http://www.mail-archive.com/pd-list@iem.at/msg00315.html</a><br>
<br>
tx for any help again,<br>
/a<br>
<br>