<div dir="ltr"><span style="font-family:arial,sans-serif;font-size:13px">I'm trying to figure out how to use the [gpio] external and I'm totally lost on how to install it and then how to use it inside PD on my raspberry pi. I did download the external from Miller Puckette's website but that is about as far as I have been able to get. I would like to be able to configure 4 GPIO pins as inputs and read their state within my PD patch.</span><div>
<font face="arial, sans-serif"><br></font></div><div><font face="arial, sans-serif">Could anyone provide me with any help on how I would go about installing this patch and using it in PD on the pi? Also, I found a thread in the list serve archive where someone had attached a draft of instructions on how to install and use the GPIO external but unfortunately the attached file was not available. Could someone send me these instructions if you have them?<br>
</font><div><span style="font-family:arial,sans-serif;font-size:13px"><br></span></div><div style><span style="font-family:arial,sans-serif;font-size:13px">Thanks,</span></div><div style><span style="font-family:arial,sans-serif;font-size:13px">Josh</span></div>
</div></div>