[PD-dev] [ pure-data-Bugs-3578095 ] netreceive doesn't work in batch mode
SourceForge.net
noreply at sourceforge.net
Thu Oct 18 15:12:31 CEST 2012
Bugs item #3578095, was opened at 2012-10-18 06:12
Message generated for change (Tracker Item Submitted) made by nobody
You can respond by visiting:
https://sourceforge.net/tracker/?func=detail&atid=478070&aid=3578095&group_id=55736
Please note that this message will contain a full copy of the comment thread,
including the initial issue submission, for this request,
not just the latest update.
Category: puredata
Group: v0.42
Status: Open
Resolution: None
Priority: 5
Private: No
Submitted By: Nobody/Anonymous (nobody)
Assigned to: Nobody/Anonymous (nobody)
Summary: netreceive doesn't work in batch mode
Initial Comment:
[netreceive] in -batch mode doesn't work, it binds the port but doesn't seem to output anything.
netstat shows a large receive queue, which presumably contains my incoming data.
$ pd -batch my-netreceive-r.pd &
...
$ netstat -au
Active Internet connections (servers and established)
Proto Recv-Q Send-Q Local Address Foreign Address State
udp 75264 0 *:5### *:*
...
$ pd -version
Pd version 0.42-6
compiled 13:48:58 Feb 17 2012
My specific use case is "one core for as-fast-as-possible analysis of an dsp system's parameter space, another for realtime/live audio, communicating via loopback network ", which perhaps is too far from the realms of sanity?
Some awkward workarounds spring to mind using -nogui instead (using a switch~'d off wrapper patch and bang it when I want dsp to run; or using a very high upsampling ratio and compensating any input to objects that use the samplerate, ...)
----------------------------------------------------------------------
You can respond by visiting:
https://sourceforge.net/tracker/?func=detail&atid=478070&aid=3578095&group_id=55736
More information about the Pd-dev
mailing list