[PD] Karplus/delay question
Miller Puckette
mpuckett at man104-1.ucsd.edu
Wed Nov 19 19:07:12 CET 2003
Yep... pd/doc/3.audio/examples/G04.control.blocksize.pd
details in chapter 7 of my book to appear in a week or so..
cheers
Miller
On Wed, Nov 19, 2003 at 04:59:16PM +0100, Thurstan wrote:
> Hello,
>
> while trying to make a simple Karplus/Strong model I ran into something I
> cannot figure out.
> I cannot seem to get the delaytime smaller than 1.55 seconds thus the
> highest note is about
> 660 Hz. I can visually get the delaytime smaller in the numberbox but this
> had no effect
> on the actual delaytime whatsoever.
>
> Does this have to do with the I/O blocksize and if so which value should I
> give this?
> If not is there another solution to get a smaller delay than 1.55 ms?
>
> I used the [vd~] and [delread~] to generate the simple feedback model. I
> also used a
> [lop~] but switched this off to measure the highest pitch the delay model
> could generate.
> For the loss in a filterless model I used [*~].
>
> Grtz Wilf
>
> _______________________________________________
> PD-list mailing list
> PD-list at iem.at
> http://iem.at/cgi-bin/mailman/listinfo/pd-list
More information about the Pd-list
mailing list