[PD] Re: rme hamerfall setup - pd hangs then quits was UPDATE insmod errors - rme hammerfall multiface UPDATE
thomas at undata.org
Sat Feb 7 17:26:37 CET 2004
rob canning a écrit :
> hi and thanks for the help so far!,
> the hdsp module is loaded /sbin/lsmod:
> snd-hdsp 46732 0 (autoclean)
> cat /proc/asound/cards
> 0 [default ]: H-DSP - Hammerfall DSP
> RME Hammerfall DSP + Multiface at 0xfeae0000, irq 5
> the motherboards intel sound chip has now disappeared but thats ok...
> i ran alsaconf again and now and everything seems a lot healthier
> the hdsploader works (the red Host light is now off) as does hdspconf and hdspmixer
> so everything looks fine but when i start pd it hangs for about 20 seconds and then outputs the following errors, then quits.
> input channels = 2, output channels = 2
> device name hw:0; channels in 2, out 2
> audio buffer set to 50
> opening sound input...
> using non-interleaved audio input
> Sample width set to 4 bytes
> ALSA: set input channels to 14
> ALSA lib pcm_hw.c:324:(snd_pcm_hw_hw_params) SNDRV_PCM_IOCTL_HW_PARAMS failed: Device or resource busy
> snd_pcm_hw_params (input): Device or resource busy
> pd: pcm.c:4887: snd_pcm_sw_params_current: Assertion `pcm->setup' failed.
> Pd: signal 6
> socket receive error: Connection reset by peer (104)
> sorry about this!
As stated in a previous mail the hdsp doesn't support interleaved mode,
and this is the only mode available in pd when using alsa at the moment.
There was a 0.35 version that had been patched to support
non-interleaved mode IIRC. Maybe you can try to use the card through the
plug layer, but performance will be suboptimal.
More information about the Pd-list