[PD] RME hammerfall
derek holzer
derek at x-i.net
Thu Apr 14 22:43:25 CEST 2005
Hi,
> fighting with an RME card for PD. <snip!> I grabbed
> this RME because it has been PD supported for years, but I cant seem
> to make things meet in the middle.....
Congratulations, you picked up one of the most complicated cards in
Linux to configure. I'd recommend reading the info on alsa-project.org
to get it up and running. You'll also need dome stuff from alsa-tools,
alsa-firmware (although I think this got absorbed into another package
during the last release cycle) and/or alsa-utils. Namely "hdsploader",
which loads the firmware into the card, and "hdspmixer" which unmutes
and sets levels for the card (it has not alsamixer interface). Another
tip is to make sure it is in the first position in your alsa.conf. If
all this is gibberish, then I even more strongly recommend looking at
the ALSA docs, or at these two pages:
http://www.linuxjournal.com/article.php?sid=7024
http://pd.klingt.org/files/hdsp-howto.html
good luck,
derek
Ti Bo wrote:
>
> Hi Kids,
>
> fighting with an RME card for PD. The card seems
> to be seen by PD (It is there under the Audio Settings
> when I turn on ALSA) but whenever I try to "Apply" the
> card selection, there is the complaint
> snd_pcm_open (input): No such device
> snd_pcm_open (output): No such device
>
> If I try a direct lsmod snd-rme9652 I get the same No such device
> complaint. The offboard box has the "HOST Error" light glowing,
> and the syslog complains too.....
>
> Well, I'm stumped. What silly detail have I overseen? I grabbed
> this RME because it has been PD supported for years, but I cant seem
> to make things meet in the middle.....
--
derek holzer ::: http://www.umatic.nl
---Oblique Strategy # 94:
"Is it finished?"
More information about the Pd-list
mailing list