[PD] comport issue

[nward04 at qub.ac.uk]

A bit of a strange one this. Hope someone can help.

I have an arduino communicating with PD via comport. If I set the  
baud rate higher than about 22000 comport throws out rubbish. The  
arduino is just counting from 1 to 10 with a 10ms gap between each  
value.
If I use zterm to look at the data its all fine and as expected.

So I was seeing this as a limitation of comport not supporting higher  
baudrate but I have also used comport to communicate with a bluetooth  
device set at 115200 and no problems at all.

Any ideas?

That zterm shows the correct info rules out a problem with the arduino.
That comport talks happily to bluetooth device I took to rule out the  
iea that it cant support higher baud.

Im on os x 10.3.9

Thanks
Nick