[PD] set up edirol ua-25

[Cesare Marilungo]

Frank Barknecht wrote:
> Hallo,
> Matthias Blau hat gesagt: // Matthias Blau wrote:
>
>   
>>> If your pd has been compiled with --enable-alsa you should be able to
>>> choose it from the menu Media->ALSA. Then do Startup->Save all settings.
>>>       
>> I can choose it from that menu but I get
>> "snd_pcm_hw_params_set_format: Invalid argument"
>> and
>> "tried but couldn't sync A/D/A
>> audio I/O stuck... closing audio"
>> messages. I get the same errors on 2 different computers which run pd
>> fine otherwise.
>>
>> I forgot to say that I use pd 0.39-1test1 and ALSA 1.0.13.
>> The sampling rate switch on the UA-25 is at 44100 and so is the setting
>> in pd's media-alsa menu.
>>     
>
> Preferably you should use 48000 with USB soundcards (or any other
> samplerate that is a multiple of 1000.) 
>   
In fact I've noticed that I can achieve much lower latency (64x2 
samples) since when I switched to 48000 with my UA-25.

But I didn't know that this setting was preferable.

c.
> Did you try the plughw:X devices in Pd's ALSA menu? And what about
> using OSS or jack?
>
> Ciao
>   


-- 
http://www.cesaremarilungo.com