[PD] alternate values per change?

[Kyle Klipowicz]

Actually, I usually connect the output of the [mod] object back into
the [f 0], but the ASCII patching made that a little difficult to
describe.

~Kyle

On 6/13/07, Mathieu Bouchard <matju at artengine.ca> wrote:
> On Wed, 13 Jun 2007, Kyle wrote:
>
> > [inlet keypress]
> > |
> > [sel 0 1]
> >           |
> >          [f 0]X[+1]
> >           |
> >          [mod 2]
> >           |
> >          [outlet to wherever]
>
> This will fail once [f] increments to 16777216 (also known as 256 cubed),
> and then it will get stuck, because that's the last contiguous integer
> that you can get with the float type that pd uses. So you need to put the
> [mod 2] within the loop so that values never get too high.
>
> as I said on the #dataflow chat, you can use [f]X[==] instead.
>
> I also suggested just using [tgl].
>
> > Note: the first outlet of [sel] is ignored.
>
> "ascii-art" is very dependent on font width, and as a result, almost
> everybody who uses that, also switches to a monospaced font, in order to
> be sure that everybody sees it the same.
>
>   _ _ __ ___ _____ ________ _____________ _____________________ ...
> | Mathieu Bouchard - tél:+1.514.383.3801, Montréal QC Canada


-- 
-----
------------
    ----     -----
---- -------- - ------
http://perhapsidid.wordpress.com