[PD] Connecting the UC-33 and pd

[marius schebella]

hi javier.
on osx you have pd-0.40... - preferences - midi settings that should 
store your settings. on other os, I don't know if that is available, but 
you still can do the following:
to see whats available in your setup open preferences - startup and add
-listdev
to the startup flags. that will printout your audio and midi devices on 
startup (later you can remove that again).
Then you can chose between a lot of startup messages (not only for midi)
Just fill them in at preferences - startup - startup flags..
Something like -audiooutdev 1 -noadc -channels 8 -midioutdev 1
-nomodiin -open /User/javie/pd/mystartpatch.pd
-audiodev: number of your sound output.
-noadc: turn off sound input, if you don't use it
-channels: number of channels
-midiindev: number of midi device
-midioutdev: you do not really need this.
-open: the patch that you want to open with the full path (better to 
have no spaces in the path, otherwise
try apostrophes.
marius.

Javier Garcia wrote:
> Hi,
> 
> when I want to control my pd patches with my UC-33 midi controller, i 
> must do these steps:
> 
> Open pd
> Media > ALSA MIDI
> Open ALSA Sequencer
> Connect UC33 with pd
> 
> Are four steps, not too much... but, Im wondering if there is any to 
> reduce them. You know, I would like to open pd and have the UC-33 and pd 
> connected without going to Media>ALSA midi and then going to the ALSA 
> Sequencer.
> 
> 
> Regards!
> 
> www.myspace.com/vjgarff
> 
> ------------------------------------------------------------------------
> Sigue de cerca las últimas tendencias y lo que más rompe MSN Vídeo 
> <http://video.msn.com/video.aspx?mkt=es-es>
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> PD-list at iem.at mailing list
> UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list