[PD] arduino question
pat at digitalworlds.ufl.edu
Fri Nov 25 05:28:39 CET 2011
that kind of works but after it sends it's message to bang something the PIRturns off when the sensor goes "off" and it sends another value is there a way to ignore that?
From: Dafydd Hughes [dafydd61 at gmail.com]
Sent: Thursday, November 24, 2011 10:43 PM
To: Pagano, Patrick
Subject: Re: [PD] arduino question
Are you trying to turn the sample on/off by comparing it to a range?
If so, have you tried something like:
On Thu, Nov 24, 2011 at 10:31 PM, Pagano, Patrick <pat at digitalworlds.ufl.edu<mailto:pat at digitalworlds.ufl.edu>> wrote:
I am using a PIR sensor with pduino playground and I have the sensor picking up movement. It's my first pd-arduino excursion so forgive the noobie-ness. When I get the out form the PIR sensor it give me a constant value of SOMETHING The entire time. It's output values range from 0.13-0.664/0.665 constantly. I just want to use the sensor to turn off/on a sample but the file is constantly being "banged" a value. How do I just out put an on/off based upon this constant stream of Data? I tried select bit that does seem to be working.
It's a simple parallax PIR sensor and I have been having good luck getting usd to wiring and the breadboard etc. but when I take the analog0 stream/port into pd I do not know how to control that data/
Pd-list at iem.at<mailto:Pd-list at iem.at> mailing list
UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Pd-list