[PD] pd + midi drumpad

[Martin Peach]

Just route the note numbers using [select] to bang the pin numbers to 
the arduino via [comport]:


[notein]
|
[select 1 2 3 4 5...] -- the midi note numbers
|    |    |    |
[2(  [3(              -- the arduino pin numbers
|
[comport]

Then in arduino you listen for incoming pin numbers with 
Serial.available(), Serial.read().

Martin


On 2012-03-28 14:14, Drake Schutt wrote:
> Hi, I'm trying to make an instrument using a drum (similar to steel
> drums), solenoid actuators, arduino, pure data, and an akai MPD 18 drum
> pad.  The drum pad has 16 pads and there will be 16 actuators.  I'm
> stuck in the pure data part and seeking some help from the list.  It
> seems to me that if I could filter the 16 note values from the midi drum
> in PD, that it wouldn't be that difficult to route each value to a pin
> on an arduino board.  I'll be using 8 outputs on two separate boards.
> The only relevant code besides pduino I've seen is a midi note filter (I
> couldn't make it useful), and some Pd patches on an MIT syllabus.  The
> MIT patches were not downloadable, they may have used Maxforlive or
> something.
>
> Thanks for any help,
> Drake
>
>
> _______________________________________________
> Pd-list at iem.at mailing list
> UNSUBSCRIBE and account-management ->  http://lists.puredata.info/listinfo/pd-list