[PD] how to install and use GPIO external

[Julian Brooks]

Hi Josh,

The thread you're after is this one:
gpio on the raspberry pi from within pd ?

(ooh - big font)

And Jaime's helpfile's attached.


That should do it.


Julian



On 13 June 2013 06:37, Josh Downing <jndowning at gmail.com> wrote:

> I'm trying to figure out how to use the [gpio] external and I'm totally
> lost on how to install it and then how to use it inside PD on my raspberry
> pi. I did download the external from Miller Puckette's website but that is
> about as far as I have been able to get. I would like to be able to
> configure 4 GPIO pins as inputs and read their state within my PD patch.
>
> Could anyone provide me with any help on how I would go about installing
> this patch and using it in PD on the pi? Also, I found a thread in the list
> serve archive where someone had attached a draft of instructions on how to
> install and use the GPIO external but unfortunately the attached file was
> not available. Could someone send me these instructions if you have them?
>
> Thanks,
> Josh
>
> _______________________________________________
> Pd-list at iem.at mailing list
> UNSUBSCRIBE and account-management ->
> http://lists.puredata.info/listinfo/pd-list
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.puredata.info/pipermail/pd-list/attachments/20130613/300caa68/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: gpio-help.pd
Type: application/octet-stream
Size: 1161 bytes
Desc: not available
URL: <http://lists.puredata.info/pipermail/pd-list/attachments/20130613/300caa68/attachment.obj>