[PD] how to install and use GPIO external
jbeezez at gmail.com
Fri Jun 14 13:21:26 CEST 2013
Meant to add:
Any other issues give us a shout and if I can help, I will.
On 13 June 2013 09:56, Julian Brooks <jbeezez at gmail.com> wrote:
> Hi Josh,
> The thread you're after is this one:
> gpio on the raspberry pi from within pd ?
> (ooh - big font)
> And Jaime's helpfile's attached.
> That should do it.
> On 13 June 2013 06:37, Josh Downing <jndowning at gmail.com> wrote:
>> I'm trying to figure out how to use the [gpio] external and I'm totally
>> lost on how to install it and then how to use it inside PD on my raspberry
>> pi. I did download the external from Miller Puckette's website but that is
>> about as far as I have been able to get. I would like to be able to
>> configure 4 GPIO pins as inputs and read their state within my PD patch.
>> Could anyone provide me with any help on how I would go about installing
>> this patch and using it in PD on the pi? Also, I found a thread in the list
>> serve archive where someone had attached a draft of instructions on how to
>> install and use the GPIO external but unfortunately the attached file was
>> not available. Could someone send me these instructions if you have them?
>> Pd-list at iem.at mailing list
>> UNSUBSCRIBE and account-management ->
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Pd-list