[PD] Pd and GEM on Udoo x86?
Marco Hugo Schretter
mco at zimt.at
Mon Jun 11 00:17:09 CEST 2018
hi,
recently i built pd+gem on udoo quad and neo like this:
http://ton.zimt.at/2018/01/22/udoo-quad-successfully-compile-and-run-pd-puredata-and-gem/
maybe this helps. it's just a quick 'what did i do'-protocol.
ciao
marco
Am 01.06.18 um 21:19 schrieb rene beekman:
> Does anyone have any experience with running Pd and GEM on an Udoo x86?
>
> I've searched the archives, but only found references to what appears to
> be an earlier model of the Udoo.
> Also, there appears to have been a special build for the Udoo available
> from Miller's site, but that seems to have stopped with version 46.6.
>
> What we need to do is to build an installation that plays full HD video
> + sound triggered by a simple rotary sensor. Each video would be 2-5
> minutes in length.
> In order to fit the projection precisely on the projection surface,
> we'll probably need a corner-pin-like functionality as well.
>
> Fairly straightforward, but since the installation needs to run in a
> museum setting, we're looking for a solution that can be switched on and
> off simply by switching power on and off.
>
> Any information or pointers would be greatly appreciated.
>
> Thanks in advance!
>
>
>
> _______________________________________________
> Pd-list at lists.iem.at mailing list
> UNSUBSCRIBE and account-management -> https://lists.puredata.info/listinfo/pd-list
>
More information about the Pd-list
mailing list