[PD] Control over audio
Chris McCormick
chris at mccormick.cx
Mon Mar 7 13:43:42 CET 2022
Hi all,
On 7/3/22 7:34 pm, Chris McCormick wrote:
> 1. Make the signal was somewhat robust to volume changes (e.g. if the
> source volume was not at max it can still be read).
> 2. Make the signal robust o quite a saturated spectrum (e.g. if the
> source is playing high bandwidth music the signal is still recoverable).
> 3. Make the signal inaudible such that if it goes into a regular mixing
> desk it doesn't make it sound bad.
Sorry to reply to my own thread but it seems like a "lock-in amplifier"
might be what I want:
https://en.wikipedia.org/wiki/Lock-in_amplifier
https://cushychicken.github.io/lock-in-amplifier-simulation/
I could put in a low-volume carrier signal up at 18kHz and use a
"lock-in amplifier" to extract the signal. Can then just gate the signal
on and off for a few ms for the sync pulse. Will experiment. Any tips on
implementing this in vanilla Pd are most welcome!
Cheers,
Chris.
--
https://mccormick.cx/
More information about the Pd-list
mailing list