[PD] Play/loop and pitch change

Chris McCormick chris at mccormick.cx
Fri Aug 8 14:45:01 CEST 2003

There's also susloop~.



On Fri, Aug 08, 2003 at 02:06:08PM +0200, S?ren Bovbjerg wrote:
> pix wrote:
> >more than likely it's your sample data.
> >
> >try a sample that is completely silent. if the click goes away, it is
> >likely your data.
> Well, the data is fine :-)
> The loops play perfectly in any soundeditor. The number of samples is 
> also the same (found with soundfiler printout), so the headers should be 
> parsed coorectly.
> >note on the tabread4~ help page that tabread4~ requires guard points
> >(although it doesn't say that explicitly). valid reads are from 1 to
> >size-2. you are reading from 0 to (size-1) if you are just multiplying a
> >phasor.
> Yes, I though it was related to something like that. The click would 
> (almost) go away if I used tabread~ rather than tabread4~ (no 
> interpolation) but sometimes a metallic sound would occur at the loop point.
> I will experiment a little bit with this and Franks suggestion.
> Thanks,
> Soeren
> _______________________________________________
> PD-list mailing list
> PD-list at iem.at
> http://iem.at/cgi-bin/mailman/listinfo/pd-list

chris at mccormick.cx

More information about the Pd-list mailing list