[PD] pd2stepper round II

[alejo d]

hia, some months ago there was a thread about controllin' step motors from
pd to the arduino, it went as it often goes, into a very technical
discussion and at the end im not sure if it is or is not possible to control
this kind of motors via pduino or any other way.. i just want to be able to
use the board and the motors from pd, can that be achived with the actual
pduino?

can anyone share a pd patch for doing so, im sending a sequence of values to
the pins in the arduino where the stepper is connected (previously tested
the wiring and it all works fine with a potentiometer) but it only tics and
doesnt move no matter the pattern i try.

this is the thread where things where being discussed:
http://www.mail-archive.com/pd-list@iem.at/msg00315.html

tx for any help again,
/a
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.puredata.info/pipermail/pd-list/attachments/20061227/6f81822d/attachment.htm>